Colido Foro Escáneres 3D 90 camera 3D scanner issues

Este debate contiene 0 respuestas, tiene 1 mensaje y lo actualizó  AlexAmery hace 2 meses, 2 semanas.

Viendo 1 publicación (de un total de 1)
  • Autor
  • #18275



    we have constructed a 90 camera based 3d scanner and we are experiencing issues with the photogrammetry. here is our setup:
    – 90 raspberry pi cameras taking uncompressed jpegs (3280 x 2464) approx 15mb for each picture.
    – custom build illuminated enclosure approx 10ft across
    – custom firmware based on raspistill
    we are trying to figure out the proper settings to run the cameras at as well as what settings to run the photogrammetry at using photoscan. we are getting approx 10,000 tie points for the sparse cloud. We have seen other scans where this is much higher. We also are having issues with entire colors being lost, such as one scan of someone we worked with who was wearing a dark blue shirt and while being on a white background there were no points at all where his shirt was.

    Any help will be apprecited.

    I didn’t find the right solution from the Internet.

    Motion graphics video animation agency

    Thank you.

Viendo 1 publicación (de un total de 1)

Debes estar registrado para responder a este debate.

chico gafas

¡Entérate de todo sobre la Impresión 3D!

*Odiamos el Spam tanto como tú. Tu email está a salvo.