Colido Foro Escáneres 3D Faro X330 Point Cloud Tilting problem?

Este debate contiene 0 respuestas, tiene 1 mensaje y lo actualizó  JosephGalvan hace 3 meses.

Viendo 1 publicación (de un total de 1)
  • Autor
  • #18045



    every Faro professionals and users, actually I am a green Faro user, now I am using Faro X330 and Scene However I have faced a quite serious problem now on the point clouds that I scanned by two Faro X330. I had actived the tilt sensor on field, used 1/4 3x scanning where the site was including outdoor and indoor, the scanning range was within 1m – 20m.
    On site, I had found that the point cloud display onboard being shift up and down exactly at the position between the starting and the end of the scan on each scan. At the time, I just thought that it was normally as the problem of display.
    However when I import all the scans into scene, I had found that the problems were still existing on the scene project, either in the panomanic or 3D view. I had also tried turn off the tilt sensor when import, the problem was still exist. Even worst was not only in vertical shift but also in longitudal shift. 😐
    Anyone can tell me why and how to solve it, how to correct the data back into right way.

    Any help will be apprecited.
    I didn’t find the right solution from the Internet.

    Marketing video production company

    Thank you

Viendo 1 publicación (de un total de 1)

Debes estar registrado para responder a este debate.

chico gafas

¡Entérate de todo sobre la Impresión 3D!

*Odiamos el Spam tanto como tú. Tu email está a salvo.