Visítanos el 25-26-27 de OCT en SIF

Visítanos el 13-14-15 de NOV en SIMO EDUCACIÓN

Visítanos el 25-26-27 de OCT en SIF

Visítanos el 13-14-15 de NOV en SIMO EDUCACIÓN

CoLiDo Foro Filamentos Problem filaments

Este debate contiene 1 respuesta, tiene 2 mensajes y lo actualizó  CalaRojas hace 1 semana, 6 días.

Viendo 2 publicaciones - del 1 al 2 (de un total de 2)
  • Autor
    Publicaciones
  • #18277

    AlexAmery
    Participante

    Hi,

    We recently bought a Beethefirst+ and while when using the a PLA white filament (A102) everything went fine, we don’t manage to print the same piece using the PLA yellow filament (A104). Everytime, after rougly 30 min the extruder is clogged. We have the same problem when testing with the PETG filament. Do you have any idea where the problem may come from?

    Any help will be apprecited.

    I didn’t find the right solution from the Internet.

    References:
    https://beeverycreative.com/forum/viewtopic.php?t=667
    Corporate Video Animation Studio

    Thank you.

    #19515

    CalaRojas
    Participante

    regards
    I think that this problem of your filamento 3d is due to the dissipation zone, since it is very important in the extruder, in it the heat of the filament that comes from the heating zone is dissipated. If the heat does not dissipate adequately in this area, the filament will clog too much and impede its correct progress along the extruder dissipation zone (due to expansion and loss of consistency). what would end up generating a plastic ball that would cause a jam inside the extruder

Viendo 2 publicaciones - del 1 al 2 (de un total de 2)

Debes estar registrado para responder a este debate.

chico gafas
Suscríbete

¡Entérate de todo sobre la Impresión 3D!

*Odiamos el Spam tanto como tú. Tu email está a salvo.