Visítanos el 25-26-27 de OCT en SIF

Visítanos el 13-14-15 de NOV en SIMO EDUCACIÓN

Visítanos el 25-26-27 de OCT en SIF

Visítanos el 13-14-15 de NOV en SIMO EDUCACIÓN

CoLiDo Foro Impresoras 3D Some issues printing PLA

Este debate contiene 0 respuestas, tiene 1 mensaje y lo actualizó  JosephGalvan hace 5 meses.

Viendo 1 publicación (de un total de 1)
  • Autor
  • #18046



    I already own a Makerbot 2x that I use for printing ABS, and I purchased the Up Mini exclusively for PLA (so that I don’t need to replace the dreaded Kapton tape frequently. I tried printing PLA three times. The first time it didn’t stick to the build plate, so I applied some Painter’s tape and the second time it printed pretty well – for about halfway through the print before it just stopped printing completely. So I took the filament out, gave it a clean cut, and reloaded it. It seemed to come out okay, so I tried another print. This time it didn’t even start printing.
    The software doesn’t help much. I think the biggest problem is that it takes so much time to even start a build. First of all, I need to re-calibrate the extruder height every time I replace the painter’s tape (maybe I need to be more careful). Then I need to click the print button, which slices, uploads, then prints. I can sit there and wait like 20+ minutes for a small print to even start. And this whole time the extruder is hot, which isn’t optimal for PLA. Plus I can’t find any option to adjust the extruder temperature (besides choosing ABS vs PLA).
    Also I’m annoyed by the constant beeping. Can I turn it off? Also, aren’t there LED’s in that thing? Why do they never come on?

    Any help will be apprecited.
    I didn’t find the right solution from the Internet.

    Promo video company

    Thank you

Viendo 1 publicación (de un total de 1)

Debes estar registrado para responder a este debate.

chico gafas

¡Entérate de todo sobre la Impresión 3D!

*Odiamos el Spam tanto como tú. Tu email está a salvo.